Aquarium planner › Substrate calculator
Aquarium substrate calculator
Enter the inside size of your tank and the depth you want. You get the volume of the bed, its weight for sand or gravel, and how many bags to buy.
How much gravel or sand do I need?
Inside floor area × bed depth gives the volume; volume × bulk density gives the weight to buy. The calculator above follows these steps:
- Measure the inside floor and choose a depth. A common hobby starting point is 1–2 in (2.5–5 cm) without rooted plants and 2–3 in (5–7.5 cm) with them (more on depth). For a slope, use the average of the front and back depths.
- Volume: length × width × depth. In centimetres, divide by 1,000 for litres; in inches, multiply by 0.016387 for litres (1 in³ = 16.387 cm³).
- Weight: litres × 1.56 kg for dry sand or × 1.68 kg for gravel, then × 2.205 for pounds. Aquasoil is sold by volume, so buy it in litres.
Example: a 30 × 12 in floor with a flat 2 in bed is 720 in³, or 11.8 L: about 40 lb of sand or 44 lb of gravel. Round up to whole bags.
How the calculation works
The bed is a block (or, when it slopes, a wedge) on the tank floor, so its volume is inside length × inside width × average depth. A bed that slopes from 2 in at the front to 3 in at the back has an average depth of 2.5 in. Measure inside the glass: the frame and glass make the outside a little larger than the floor you are covering.
Litres = length (cm) × width (cm) × average depth (cm) ÷ 1,000
Weight is volume × bulk density. Dry sand is about 1.56 kg per litre and dry gravel about 1.68 kg per litre (Engineering ToolBox density table, read 24 October 2026). Real products vary with grain size and shape, so round up and keep the receipt. Aquasoils are light, porous and sold by volume. For those, choose “by volume” and enter the bag size in litres.
Is “1 lb per gallon for 1 inch” right?
The old rule works only for tanks of standard proportions, because substrate covers the floor, not the volume. A 20 gallon long measures 30¼ × 12½ in outside (378 in²): 1 inch of sand over that footprint is about 21.2 lb, close to the rule. A 20 gallon high measures 24¼ × 12½ in, so the same inch takes only about 17.0 lb. A 55 gallon (48¼ × 12¾ in) needs about 34.6 lb per inch, well below the 55 lb the rule suggests. The tank size chart lists the figure for each common size.
How deep should the bed be?
- 1–2 in (2.5–5 cm) of sand or fine gravel is usual for a tank without rooted plants and is easy to clean.
- 2–3 in (5–7.5 cm) is common for rooted plants. Sloping it higher at the back adds depth where the tall plants go.
- Bottom dwellers such as corydoras are usually kept on smooth sand or fine rounded gravel rather than sharp grit.
These are common starting points, not rules. Check what your plants and fish need.
Substrate and your water volume
The bed takes up space that would otherwise be water. Finpado's aquarium planner subtracts it once: enter the average substrate depth under “Fine-tune usable water” and the net water figure, water-change volume and water weight all use the reduced amount. See the net water formula for the details.
Finpado runs in your browser; nothing you enter is sent to a server. Bag counts are rounded up to whole bags.