Aquarium planner › Guides › 40 gallon tank dimensions

40 gallon tank dimensions: the 40 breeder in detail

By Finpado · Published 28 October 2026

Short answer

The standard 40 gallon tank is the 40 gallon breeder: 36 3⁄16 × 18¼ × 16 15⁄16 in outside, or 91.9 × 46.4 × 43.0 cm. It weighs 58 lb empty and about 458 lb filled.

The Aqueon standard range has one 40 gallon tank, the breeder. It is an unusual shape: 3 feet long but 18¼ inches front to back, nearly as deep as the 75 and 125 (18½ in). That depth also makes it, among the standard sizes up to 125 gallons, the one whose real water comes closest to its label.

40 gallon breeder specifications

Outside length × width × height36 3⁄16 × 18¼ × 16 15⁄16 in91.9 × 46.4 × 43.0 cm · Aqueon 40 Breeder, measured outside the frame
Length36 3⁄16 in (3 ft 3⁄16 in)92 cm
Footprint (stand top needed)36 3⁄16 × 18¼ in660 in², 4.6 ft²
Inside dimensionsNot publishedmeasure glass to glass for an exact volume
Label volume40 US gal151 L
Outside box volume48.4 galcalculated: L × W × H ÷ 231
Water it holds, set up37.5–39.8 gal1 in below the rim, 2 in substrate; lower figure with ¼ in glass (illustration)
Empty weight58 lbcatalog
Filled weight458 lb208 kg · catalog; varies with substrate and decor
Load on its footprint100 lb/ft²calculated: filled weight ÷ footprint
Sand for 1 / 2 / 3 in37 / 74 / 111 lbdry sand 1,555 kg/m³, outside floor
Gravel for 2 in80 lb5 × 20 lb bags · aquasoil: 21.6 L
25% water change9.4 gal2 trips with a 5 gal bucket, from the lower water figure

Source: Aqueon aquarium catalog, p. 66. Tanks sold as “40 long” or “40 tall” by other makers are different shapes.

What other makers publish for the 40 breeder

Maker and sourceWhat is publishedFigure
AqueonAqueon catalog, p. 6640 Breeder tank, outside36 3⁄16 × 18¼ × 16 15⁄16 in
MarinelandAquarium Stand for 40-Gallon Breeder AquariumsStand: fits a tank base up to38 × 19 instand 38.38 × 19.25 × 27.38 in

Marineland does not list a bare 40 breeder size on its website, but it does state what its 40 breeder stand accepts: a base up to 38 × 19 in. Aqueon's breeder, at 36 3⁄16 × 18¼ in, fits inside that with 1 13⁄16 in of length and ¾ in of depth to spare. That is the practical check for any stand: the tank's outside footprint must sit fully on the top, frame and all.

Why the breeder holds close to its label

Most standard tanks hold well under their label once set up: a 55 ends up near 82% and a 20 long near 73%. The 40 breeder ends up near 94%. The reason is in the box: 36 3⁄16 × 18¼ × 16 15⁄16 in is 48.4 gallons outside, about a fifth more than the label, so there is room to lose an inch at the rim and two inches to gravel and still be close to 40. If you dose by the label, the breeder is one of the few sizes where the label is nearly right.

Finpado plan summary for the 40 gallon breeder preset with net water and water weight
The 40 gallon breeder preset in the free Finpado planner, filled 1 in below the rim. Add your substrate under “Fine-tune usable water” and the net water drops to the figure you will dose by.

Floor: more than a 55

The breeder's footprint is 660 in² against a 55 gallon's 615 in², and it is 43% deeper front to back. It is a foot shorter, though, and the 55 is the better choice where a care guide asks for 4 feet of length. Filled, the breeder is 167 lb lighter and puts 100 lb on each square foot of stand against the 55's 146. More comparisons: how standard tank footprints compare and 55 gallon tank dimensions.

How much does a 40 gallon tank weigh?

458 lb (208 kg) filled and 58 lb empty, per the catalog: 167 lb lighter than a 55 for a bigger floor. More floor for less weight is the trade the breeder makes against the 55.

How much gravel for a 40 gallon breeder?

The breeder's wide floor takes more substrate than a 55: about 74 lb of sand or 80 lb of gravel for 2 in (5 bags of 20 lb), against 69 lb of sand in a 55. A deep planted bed of 3 in is 111 lb of sand, or about 21.6 L of aquasoil per 2 in. The substrate calculator handles a slope.

Stand

The breeder needs a stand that is 18¼ in deep, which rules out stands made for 30 or 55 gallon tanks (12⅝ and 12¾ in deep). The top must cover 36 3⁄16 × 18¼ in and be rated for more than 458 lb.

Open the 40 breeder in the free planner

Free and no sign-up. The planner uses the breeder's full footprint, so its space screen shows what the extra depth is worth for your shortlist.

Sources

Dimensions and weights: Aqueon aquarium catalog, p. 66, read 28 October 2026. Second maker: Marineland's own product page (linked in the table above), read 28 October 2026. Densities: Engineering ToolBox (sand, gravel) and USGS (water). Everything else is arithmetic with the same code as the Finpado tools (method).